What does error 3 mean on a hot tub?
ambient air temperature is too low
Is there an E03 error code displaying on your Lay-Z-Spa pump? This means the ambient air temperature is too low.
Can you run a hot tub without a filter?
Don’t Run It Without the Filter Running the pump in a spa for too long without a filter can lead to clogged pump impellers and a fast decline in the water quality. So if you need a new filter, replace it as soon as possible. And in the meantime, only run the pump on low speed instead of turning it off.
How do you reset a Jacuzzi tub?
How Do I Reset a Jetted Spa?
- Drain the water using the main control panel and turning the valves below.
- Turn your spa off using the main control panel.
- Clean the spa completely, paying special attention to the jets and filter.
- You will find a reset button typically on the heater unit.
Is there a reset button on a hot tub heater?
Locate the spa’s high-limit reset. This is a red button found on many spa packs. It may be located on the heater and covered by a rubber nipple.
How do you clear the error code on a lazy spa?
Run the spa with the heating and filtration system. If the E02 error code disappears for 2 to 3 hours, the issue is caused by the filter housing black membrane being perished or twisted….Please follow these steps to resolve this:
- Remove the stopper caps.
- Turn the pump off and on at the power supply.
- Press the reset button.
What does eo2 mean on hot tub?
The E02 error code can occur when the filters are dirty or blocked. SOLUTIONS WASH OR CHANGE THE FILTERS. Remove the filter cartridge from the filter housing.
Is there a reset button on a hot tub motor?
There are generally two “hard resets” in hot tubs, the GFCI, and the high limit reset. The GFCI pops if there is any type of electrical short (such as water getting into the heating element, the reset on that can be in one of three places.
Where is the reset button on my Jacuzzi tub?
The button is typically located on the side of the control box behind the hot tub’s removable panel on the front side. Similar to disposal reset buttons, simply press the small red button in to reset it. But don’t press it until you’ve figured out why it tripped. Resets are like circuit breakers.
Why does my lazy Spa keep saying error?
During the use of the spa, the warmth of the water expands and contracts the filter housing plastic. If there is a small or invisible crack on the plastic housing, this can cause the E02 error code. However, there may be a blockage in this also which can cause this error code.
How do I fix error code e03 on a lazy Spa?
This error code is visible if the ambient air temperature is too low outside. The spa pump will not run if the air temperature is below 4-6°c. Remove the pump from the spa by placing the stopper caps on the inside of the spa over the debris screens.