What does a Dynojet tuner do?
It can track and monitor your progress to guide you on how to make perfectly-optimized tunes for your ride or drive style. If you’re looking for something even easier, you can purchase one of our thousands of tested tunes from our online library, perfected for stock or heavily-modified vehicles.
How do I know if my target tune is working?
How can I tell if Target Tune is working? At any given operating condition there is an AFR, or Lambda value the ECM is trying to achieve. Using the fuel table as a reference, you can simply monitor the real time AFR or Lambda on your Power Vision while riding, or create a datalog to verify.
How do I know if my Dynojet AutoTune is working?
The easiest way to determine if the AutoTune is working is to go for a ride, come back, plug the Power Commander into a computer and look at the trim table(s). If there are values in any cell other than zero, AutoTune is working. If the table is all zeros, AutoTune is NOT working.
How do I set up a target tune?
Plug the connectors from the Target Tune into the stock O2 sensor connectors (Fig. A). Plug the Target Tune lead with the YELLOW/ ORANGE wire into the FRONT cylinder stock O2 connector. Plug the Target Tune lead with the YELLOW/GREEN wire into the REAR cylinder stock O2 connector.
How do I install dynojet target tune?
Where do I mount my power commander?
Position the commander Find somewhere protected from rain and engine heat to mount the power commander. A good place is normally under the seat, and you get a sticky Velcro patch to secure it there. Feed the PC wiring harness along the subframe rails, and down towards the battery and injectors.
How do I know if my Target Tune is working?
How do you use Dynojet AutoTune?
How To Configure AutoTune
- Select Power Commander Tools > Configure > AutoTune.
- Select the AutoTune Enabled box to enable or disable AutoTune.
- Select the Enable Hardware Switch box.
- Enable or disable the Require Run Time.
- Enable or disable the Require Engine Temp.
- Enter the Trim Settings.
- Click OK to accept the changes.