Is there a Dana 35 front axle?
The most common Dana 35 applications are as a rear axle in the Jeep Cherokee, Jeep Wrangler, and Jeep Comanche and as a front axle in the Ford Explorer and Ford Ranger.
How big of a tire can a Dana 35 handle?
The majority of failures on a Dana 35 axle relate to weak 27-spline C-clip-style axleshafts. The factory never intended for these shafts to last with larger than 33-inch tires.
What vehicles had a Dana 35?
The Dana 35 (as well as the AMC-15) are found in a wide variety of vehicles; the most common Dana 35 applications are as a rear axle in the Jeep Cherokee, Jeep Wrangler and Jeep Comanche. It also is a common front axle in the Ford Explorer. In the 1990s Ford used the Dana 35 as a front axle.
Can a Dana 35 handle a locker?
The tiny 1.18-inch 27-spline shafts that are only marginally bigger than the 1.16-inch shafts found in a Dana 30 front axle. In most stock applications, they will live indefinitely; however, adding a locker and larger-than-stock tires or driving abusively can snap them.
Can Dana 35 Handle 35 tires?
And the front axle never sees more than about 50 percent of the stress that the rear axle does. 35″ tires are not recommended on a dana 35.
How can you tell the difference between a Dana 30 and a Dana 35?
The Dana 30 will only be found as a Jeep front axle while the Dana 35 will only be found as a rear axle on Wranglers. Dana 35 axles have earned a very poor reputation in the off-roading world, however, it is a great axle for stock Wranglers.
Does a Dana 35 have C-clips?
The ’90-and-later Dana 35s have C-clips that retain the axles in the housing.
Can a Dana 35 Handle 35 inch tires?
Your friend’s front axle is a dana 30, not a dana 35. And the front axle never sees more than about 50 percent of the stress that the rear axle does. 35″ tires are not recommended on a dana 35.
Can you put 4.10 gears in a Dana 30?
Yes you can install lower gears in the front dana 30 axle, and of course you need to have the rear match.