How to install fuel injectors on the dt466e?
Line up the injector with the connector the connector facing the rear DT466E or the direction the originals faced line up the bolt holes in the head with the bolt holes in the injector hold down bracket. And with firm steady downward HAND pressure set the injector into the cup and the nozzle/tip into the cylinder.
How to tell which one is bad on the DT466?
Is there anyway to tell which one is bad on the DT466? You may have a injector tip cracked or worse yet broken off, Use a temp gun and find the defective cyl by measuring temps of exh manifold per cyl.
How do you put the injector in the cylinder?
And with firm steady downward HAND pressure set the injector into the cup and the nozzle/tip into the cylinder. The injector will still stick out make sure you have the injector positioned correctly as removing may damage the o rings.
How do you remove fuel injectors from a car?
Removing the injectors involves removing the valve cover and gasket, then you have to remove the HP oil rail before tackling the Torx bolts holding the injectors in place. Installing is a reverse process and you should have a qualified shop do the testing for you.
What size hold down do I need for injectors?
More sharing options… Injector hold downs, 120 in/lb. Valve cover, 13 ft/lb. Adjust the valves while you’re in there, as they will be loose and the guy will feel the power when they’re set right. Good Luck! More sharing options…
How do you put fuel injectors in a Ford Ranger?
Install the hold down screws in their correct locations and use the hold down bolts to press the injector into the cup by alternating between the two bolts ½ turn at a time so you don’t tweak the injector. When you feel resistance get out the inch pound torque wrench Torque the injectors to 70 INCH POUNDS
How do I connect the injector to the valve cover?
Squeeze the tabs on the pass through connector on the valve cover and push the connector into the valve cover. Otherwise you will destroy the internal injector wire harness.