How do you reset a Curtis tea brewer?
To reset the control panel and return to normal operation, press ◉ for 5 seconds. Turn on brewer at the control panel ON/OFF button. Press and hold ③ button (see illustration, page 2) for 5 seconds. Water Temperature will be displayed (temperature in heating tank).
How do I reset my Curtis coffee maker?
Refill the tank and push the hi-limit reset button. Faulty hi-limit switch – If there is water in the tank but still no power, push the hi-limit reset button to restore power. If power isn’t restored, the hi-limit switch will need to be replaced.
How do you clean a Curtis coffee dispenser?
Cleaning Airpot Brewers
- Turn off the machine – Turn the button off on the front control panel and unplug the power cord.
- Wipe down the exterior – Use a damp cloth to wipe down any debris or spills from the exterior surfaces.
- Clean the sprayhead area – Slide the brew cone out of the coffee maker.
How do I fix the water level error on my Curtis coffee maker?
My G3 brewer is indicating a “Water Level Error”, what should I check?
- Verify that the water supply to the brewer is on.
- Ensure that there is a flow rate of 1 GPM.
- Check that the inlet valve is operating correctly.
- Reset the rear toggle switch – the board should display “Filling”, “Heating” “Ready to Brew”.
What does Rinse server before brewing mean?
Press ◉ to turn ON or OFF. The message displayed is “Rinse Server Before Brewing”. This message will alternate; two seconds with Rinse Server Before Brewing, then Curtis READY TO BREW will appear for six seconds. Language (Factory set to English)
How do you clean a tea funnel?
Mix 1 tbsp. of baking soda in a bowl of hot water. Soak your tea strainer in this solution for 3-4 hours. Then, rinse thoroughly and wash your strainer with dishwashing liquid.
What is a Deliming spring?
A deliming spring is a long, flexible, compact spring used as a tool to remove lime deposit from your coffeemaker. Simply unscrew your deliming spring and insert your deliming spring in your coffeemaker as far as it will go.
How do I clean my Curtis Thermopro?
– Clean with warm water and dishwashing detergent. – Use a sponge cleaning brush to scrub inside. – Rinse thoroughly with hot water.
How long does a Curtis cappuccino take to heat up?
45 minutes to 1 hour and 15 minutes
What is the initial heating time once the unit is installed? Depending on the ambient temperature, it can take 45 minutes to 1 hour and 15 minutes to heat up.
How do you make coffee in a Curtis coffee maker?
Step 1—Place a paper filter into the brew cone and evenly pour coffee grounds into the filter. Step 2—Slide the brew cone all the way back into the guide rails. Step 3—Once the green “Ready to Brew” light turns on, add one decanter (around 64 oz.) of room temperature water into the opening on the top cover.