How do I restore my access point to factory settings?

How do I restore my access point to factory settings?

Press and hold the Reset button of your access point for 30 seconds. Once the access point is reset, perform a powercycle….

1. Open the access point’s web-based setup page.
2. Click the Administration tab and then click on the Factory Defaults sub-tab.
3. Click Restore All Settings.

How do I hard reset my Linksys router?

1 Factory Reset

1. Ensure the router is ON.
2. Using a paper clip, push and hold the Reset button.
3. Hold the reset switch for 10-15 seconds.
4. Disconnect and reconnect the router’s power adapter.
5. Once it fully reboots, you can use the default username and password to connect the device.

How do I reset my WAP54G access point?

How to Reset a WAP54G Password

1. Take a small paperclip and bend one end of it so that it’s straight.
2. Locate the reset button on the back of the router.
3. Release the button and wait until the lights stop blinking while the access point resets itself.

How do I wipe my Cisco AP?

Reset Cisco Wireless AP to factory defaults

1. Connect the console cable.
2. Unplug the power or network cable if connected to a POE switch.
3. Press and hold the Mode button.
4. Plug the power back into the AP.
5. Wait until the output on the console says button is pressed.

How do I change my access point password?

How to Change Your Router’s Login Information

1. Enter your router’s IP address into your favorite web browser.
2. Log in with the default username and password (both admin, usually).
3. Go to settings.
4. Select Change Router Password or a similar option.
5. Enter the new password.
6. Save the new settings.

How do I reset my Cisco wireless router?

The default username is cisco and the default password is cisco. Step 1. Press the Reset button located at the back of the device with a pin for approximately 15 seconds or until the power light on the front of the device starts flashing. The Router reloads and is set to the default configuration settings.

How do I Reset my Cisco wireless router password?

Cisco 3848V change password

1. Visit the Admin Console by visiting 192.168.
2. Log in with the following information:
3. Click Login.
4. Click Wireless at the top of the page.
5. Click the Wireless Security tab.
6. Under 2.4GHz Wireless Security, type a new password for the network in the Pre-Shared Key field.

How do I Reset my Cisco WAP to factory default?

How to Reset My Cisco WAP 1 Log in to the web-based utility of your WAP and choose Administration > Reboot. 2 Click the Reboot To Factory Default button. 3 Click OK in the confirmation window. See More….

How do I Reset my WAP?

If power is supplied through Power over Ethernet (PoE), unplug your Ethernet connection for three seconds then plug it back. Press the Reset button for about three seconds only, or until the lights go off. Step 1. Log in to the web-based utility of your WAP and choose Administration > Reboot. Step 2. Click the Reboot button. Step 3.

How do I Reset my wrvs4400n router IP address and password?

Reset WRVS4400N Router IP address and password – Cisco Community. 1) Hold the reset button for 30 seconds with the power on. 2) While still holding the button, power the router off for 30 seconds. 3) Continue to hold for 30 seconds after power on, then release.

What happens when I reboot the wireless access point (WAP)?

Rebooting or restarting the Wireless Access Point (WAP) deletes the logs stored in the volatile memory. This process is performed when certain changes in the settings need a reboot or if the WAP is not responding or booting up properly.