How do I know what gear ratio my Ford Explorer has?
The only way to find out is from the tag if you can get nothing from the vin. depending on the year the most common gear ratio was a 3.55 of 3.73 worst case scenario you can pull the cover and possiblly see the face of the pinion gear and the ratio is stamped on it.
What rear end does a 99 Ford Explorer have?
All Explorers came with the 8.8 rear end you will want to get one from a ’95-’01 so that it has disc breaks.
What is the gear ratio in a 1998 Ford Explorer?
This rear diff can be configured with either a 3.55, 3.73, or 4.10 gear ratios, depending on the stock configuration of your Explorer SUV.
How do I find the rear axle ratio on my Ford?
How Do I Find the Axle Ratio and Limited Slip of My Ford Vehicle?
- Locate the Safety Compliance Certification Label on the driver’s side front or rear door panel.
- Find the word AXLE under the bar code.
- Find the two-digit code under AXLE.
How do I know if my Ford Explorer is 8.8 rear end?
You can identify the Ford 8.8-inch rear by its rear cover. It has a thin metal or plastic 10-bolt cover, and the bolts are 7/16-inch thread. The cover is not quite square, measuring about 101/2 inches high by 11 inches long. The 8.8-inch pinion shaft is 15/8 inches and has 30 splines.
What year Explorer had 8.8 rear end?
First appearing in 1977, the 8.8 is found in almost all Ford V8 cars from ’86 on, and in V6 Rangers and Explorers.
How can I tell what gear ratio I have without pulling cover?
With the transmission in neutral, rotate the rear driveshaft by hand. Count the number of driveshaft revolutions required for one revolution of the tire. If the driveshaft turns approximately 3-1/2 times, you have a 3.54 ratio, etc.
What axle ratio do I have?
Method 1: Count the number of teeth on the ring gear and the pinion. Divide the number of the ring gear’s teeth by the number of the pinion’s teeth. This will give you the axle ratio.
What year Ford Explorer has 8.8 rear end?
What years did the Ford Explorer have a solid rear axle?
The Ford Explorer used it until it switched to an independent rear suspension in 2002. The exception is the 2002-2003 Ford Explorer Sport which still used the solid rear 8.8-Inch axle.
How big is the axle tube on a Ford Explorer?
The Ford Explorer 31-spline 8.8-Inch axle tube is 3.25 inches in diameter. The Ford F-150 / Bronco 31-spline 8.8-Inch axle tube is 3.25 inches in diameter.
What is the difference between Ford Explorer and Ford Ranger axle?
The 8.8-Inch axle used in the Explorer is highly desirable because it came with 31-spline axles over the typical 28-spline found in the Ranger version. There’s a 20-25 percent difference in strength between this Explorer 8.8 and the Ranger 8.8. The bigger 31-spline axle accounts for most of that, but the 3.25-inch tubes also help.
What kind of axle does a Ford Explorer FX4 have?
The 2003-up FX4 (non-Level II) is essentially the same as the 1998-2002 Off-Road except that a regular Ford limited-slip in a regular 8.8-inch was included. Ford Explorer: The 8.8-Inch axle came in Ford Explorers (and Mazda Navajo) in 1990 as a 1991 model year. The Ford Explorer used it until it switched to an independent rear suspension in 2002.