What brand carburetor does STIHL use?
Stihl 018 Walbro Carburetor No. 1130-120-0601. This aftermarket Stihl carburetor replaces part number 1130-120-0600 Walbro WT-325A. Make sure your carburetor is a Walbro not Zama.
What does LA mean on STIHL carburetor?
The LA setting on Stihl chainsaws is controlled by a screw on the outer housing of the engine that adjusts the flow of fuel and air through the carburetor. This screw is inside the engine housing on the carburetor, but is accessible through a hole or gap in the outer housing of the saw.
How do I reset my STIHL carburetor?
Return a type A carburetor to its factory setting by turning the “H” screw counterclockwise until it stops, turning the “L” screw clockwise until it is seated, then backing it off one full turn.
Does Stihl use Walbro carburetor?
Product Description. Listed Is A High Quality Carburetor Kit (Gaskets And Diaphragms) Which Fits The Following Stihl Models That Utilize A Walbro Carburetor: 021 Ms 210 023 025 Ms 250 026 Ms 260 028 031 032 009 010 011 012.
Why does my Stihl chainsaw bog down when I give it gas?
The reason for that may be you’re using the saw at altitude or the carburetor adjustment has simply slipped. The saw also won’t operate well at speed if the air filter or spark arrestor or carburetor are dirty.
What is the H and L on a carburetor?
They are typically labeled L (low speed jet), H (high speed jet), and I (idler jet).
Why does my chainsaw dies when I give it gas?
If the filter becomes clogged, not enough fuel will reach the engine for it to run properly. Because your chainsaw will idle, but dies when it is revved up to full power, it means that the filter is only partially clogged; it will allow enough fuel to the engine to run on idle, but not enough to sustain full throttle.
Why does my Stihl chainsaw not idle?
The two most common reasons a chainsaw won’t idle are a blocked air filter and an idle screw out of adjustment. Other possible causes include: Dirty Air Filter. Idle Screw out of Adjustment.
What does L and H mean on a carburetor?
The letters on the screws represent High (H), Low (L) and Idle (T). The H screw regulates the Air/Fuel mix during high RPMs, while the L Screw does the same during low RPMs. The T screw regulates how much fuel is sent to the carburettor while idling until the throttle is pressed.
Who makes Walbro carburetors?
The Carlyle Group
Tokyo, Japan – Global alternative asset manager The Carlyle Group (NASDAQ: CG) today announced that it has acquired 100% of the outstanding shares of Walbro Engine Management, a global small engine parts manufacturer, from Sun Capital Partners.