How do you set a jumper?
Jumper settings for 2 hard drives and 1 CD/DVD drive
- Set the first hard disk jumper as Master (alternatively, Cable Select selection can be used but set the second hard drive to Cable Select).
- Set the second hard disk jumper to Slave (use the Cable Select selection if Cable Select was set on the first hard drive).
How do I check jumper settings on my hard drive?
To find out precisely what the jumper pins do on your hard drive, just search “jumper pins” along with the model number and manufacturer of your drive. You’ll find the relevant support site that tells you which ones to use. Western Digital’s instructions for jumper pin settings on some SATA hard drives.
What is harddisk jumper?
You may have pins on the back of your hard drive that nothing is connected to. These pins are called jumpers, and are used to enable specific types of settings. They’re not used so much with modern hard drives, except in some special circumstances.
How do I enable SATA in BIOS?
In the BIOS Utility dialog, select Advanced -> IDE Configuration. The IDE Configuration menu is displayed. In the IDE Configuration menu, select Configure SATA as and press Enter.
What is jumper setting?
In electronics and particularly computing, a jumper is a short length of conductor used to close, open or bypass part of an electronic circuit. They are typically used to set up or configure printed circuit boards, such as the motherboards of computers. The process of setting a jumper is often called strapping.
How do you use jumper pins?
To change a jumper setting, pull the plug off its pin(s) and carefully fit it down onto the pin(s) indicated. A jumper is referred to as open or unjumpered when the plug is pushed down over only one pin or if there is no plug at all. When the plug is pushed down over two pins, the jumper is referred to as jumpered.
What do the hard drive jumper settings mean?
Each hard drive setting is used by the Computer’s BIOS to tell the system where the hard drive is located and what priority it has in relation to the other drives. Most hard drives and computers that were manufactured after 2002 probably do not need to have the hard drive jumper settings changed – this includes all SATA drives.
How do I set the hard disk jumper to master?
Set the hard disk jumper as Cable Select or Single. Connect the drive using the Master connector on the primary IDE cable. Set the first CD/DVD drive jumper to Master (alternatively, Cable Select can be used if you set the second CD/DVD drive selection to Cable Select). Connect the drive using the Master connector on the secondary IDE cable.
What do the Jumper pins on the back of your hard drive?
What Do The Jumper Pins On The Back Of Your Hard Drive Do? You may have pins on the back of your hard drive that nothing is connected to. These pins are called jumpers, and are used to enable specific types of settings. They’re not used so much with modern hard drives, except in some special circumstances.
Do I need jumpers for SATA external hard drive?
If you are using SATA drives, you do not need to set jumpers for master and slave because each drive gets its own cable. Additionally, how do I power a SATA external hard drive? The process of housing the hard drive is very simple. Open the enclosure along the designated line.