How do I know if my inlet valve is bad on my dishwasher?

Posted on

How do I know if my inlet valve is bad on my dishwasher?

Signs pointing to a faulty inlet valve include:

  1. Leaks that fill the dishwasher when it’s off.
  2. Inadequate water for a cycle.
  3. A bad inlet valve can lead to leaks from the dishwasher onto the kitchen floor.
  4. Most inlet valve malfunctions stem from a defective seal or solenoid failure.

How do you fix the water inlet valve on a refrigerator?

Instructions

  1. Shut off the power and water supply. Safely store any food that could deteriorate while the refrigerator is shut off.
  2. Disconnect the water supply line.
  3. Remove the back panel.
  4. Remove the mounting bracket.
  5. Remove the valve assembly.
  6. Install the new valve assembly.
  7. Reconnect the wire harness.
  8. Mount the new valve.

How do you know if your dishwasher water inlet valve is bad?

How do you know if your dishwasher check valve is bad?

The check valve stops wastewater from re-entering your dishwasher through the drain hose. If the water in your dishwasher is draining, but then backs up once the drain pump turns off, you are most likely dealing with a faulty check valve.

Why is my KitchenAid dishwasher not getting water?

If the water valve is clogged or defective, water will not flow into the dishwasher. Water inlet valves are not repairable—if the valve is defective, you must replace it.

How do I replace the water inlet valve?

Pull your refrigerator from the wall until you can access the power cord.

  • Turn off the refrigerator water supply valve. The supply valve connects to the wall behind the refrigerator or beneath the kitchen sink.
  • Remove the screws holding the lower access panel to the bottom of the refrigerator.

    • How to replace the water inlet valve?

    A compatible replacement water inlet valve

  • Work gloves
  • A towel and,optionally,a bowl to catch water leaks
  • Phillips and flathead screwdrivers
  • A nut driver
  • A wrench (we used a ½ inch wrench for this job)
  • A razor blade

    • How to test the water inlet valve?

    – Is not making ice – Ice is too large/small – Ice tastes bad – Ice is discolored – Water is leaking from the unit

    How to replace a dishwasher water inlet valve?

    Unplug the dishwasher or otherwise remove the power source so you can safely handle electronic components.

  • Locate the water valve and look for a sticker or stamping on the metal of the valve.
  • For AC power,create a test cord so you can apply power to the valve in order to test its function.